ITEM UNIT SA-40 SA-45 SA-50
CAPACITY
Centre height.............mm (in.) 605 (23.81) 675 (26.57) 760 (29.92)
Swing over bed............mm (in.) 940 (37) 1010 (39.76) 1095 (43.11)
Swing over cross slide....mm (in.) 870 (34.25) 940 (37) 1025 (40.35)
Distance between centres..mm (in.) 700 (27), 1200 (47), 1700 (67), 2200 (86)
3200 (126), 4200 (166), 5200 (206)
BED
Width / Slant angle.......mm (in.) / deg 1580 (62.20) / 60°
CARRIAGE
Width of cross slide......mm (in.) 600 (23.62)
TURRET
Standard tool post........Polygon Disc / VDI disc
No. of tool stations......V12 / V8;V12
Turning Tool Size.........mm (in.) 32 x 32 (1.25)
Boring Tool Size(max.)....mm (in.) 63 (2.5)
TRAVEL
Cross slide(X axis) travel....mm (in.) 555 (21.85)
Longitudinal(Z axis) travel...mm (in.) 700 (27), 1200 (47), 1700 (67), 2200 (86)
3200 (126), 4200 (166), 5200 (206)
Cutting feed rate.............mm(in.)/rev X axis : 0.001~250(0.00004~9.84) ; Z axis : 0.001~400(0.00004~15.75)
Rapid travel..................M.(Ft.)/min X axis : 6(19.68) ; Z axis : 6(19.68)
Ballscrew diameter............mm (in.) X axis : 50(1.96) ; Z axis : 80(3.14)
TAILSTOCK
Quill type...................Built-in type, Rotating tailstock quill
Quill diameter...............mm (in.) 235(9.25)
Quill travel.................mm (in.) 200(7.87)
Internal taper of quill MT#6
MOTOR
Headstock oil refrigerator...18,000BTU(4,500Kcal)
Main spindle.................KW(HP) 30/37(40/50)-STD. ; 37.5/45(50/60)-OPT.
Axis servo...................KW(HP) X axis : 7(9.387) ; Z axis : 7(9.387)
Hydraulic tank...............KW(HP) 3.7(5)
Coolant pump.................KW(HP) 1.05(1.4)
Controller...................FANUC 0i-TF series-STD ; FANUC 31i-B series / Other required-OPT.Note :
(1) X and Z axes actual cutting diameter will change when equipped with different turrets.
(2) Specifications are subject to change without notice for improvement